Jobsite Inspection: Checking the Marks

st_2.png

The marks at your jobsite, and how you interpret them, can make or break your safety. The most important thing you can do is compare the marks to your positive response codes. There can be some obvious signs of something wrong.

Do the Marks Match What You See?

Let's say you arrive at the work site and see marks for communications, but from positive response you learned there should also be marks for electric.

Why would this happen?

  • The locator could have misunderstood the marking instructions and marked the wrong place within your work site.
  • A completely different work site was marked.
  • It could also mean that the marks were destroyed before you got to the work site.
  • Maybe kids or vandals pulled up the flags.

These are all possibilities and you shouldn't begin until you've done some checking. In the situation mentioned in the first paragraph, the best thing to do is contact the electric company.


Identifying Properly Placed Marks

When flags and paint are used together, flags are usually placed within the borders of the paint mark. If you find flags set away from the paint mark, they may have been tampered with. Once again, if something doesn't look right to you, STOP and check it out. A call to the facility owner may be necessary.

The following pictures show proper paint and flag placement.

flag_proper.jpg

NEVER assume that "no marks" at the work site means "no lines."

Others have, particularly when other facility marks are visible within the work site. This incorrect interpretation can result in a damage or worse, injuries and death.

In the left photo below there are no locate marks. The excavator assumed that meant no lines were present. It was the wrong assumption to make. Make sure you check the positive response system and verify, verify, verify the lines that are present.

backhoe_unmarked.jpg